Dometic FreshWell FWX4350EHP Instrucciones De Montaje Y De Uso página 24

EN
Item
18
bu
bn
ye
gn
rd
bk
vt
• Ensure that the voltage specification on the type plate is the same as that of the power supply.
• Install an all-pole switch with a contact opening width of at least 3 mm on the installation side.
• If the under-bench air conditioner is powered by the mains, install a 2-pole switch that interrupts the AC volt-
age supply in case of overcurrent.
• If the under-bench air conditioner is powered by the mains, ensure that the AC voltage supply has a residual
current circuit breaker.
• Ensure that the grounding cable of the under-bench air conditioner is connected to the vehicle's grounding
system.
Making openings
1. Mark the position and size of the openings using the template.
Fig.  on page 5
2. Drill out the corners.
Fig.  on page 5
3. Cut out the openings using a keyhole saw or a similar tool.
4. Drill out a condensation water drainage opening with a diameter of 32 mm.
5. Mark the position of the mounting brackets (Fig. , 1) and the fastening brackets (Fig. , 2).
Fig.  on page 5
Installing the fastening brackets and belts
Fig.  on page 6
1.
Fasten the fastening brackets (Fig. , 1).
2. Pull the belts through the fastening brackets (Fig. , 2).
3. Install the drain pipes underneath the under-bench air conditioner (Fig. , 3).
4. Fasten the under-bench air conditioner with the belts (Fig. , 4).
Installing the mounting brackets
Fasten the under-bench air conditioner with the 2 angle profiles. Use 3 screws for each mounting bracket to fix
it.
Fig.  on page 6
22
Description
Evaporator fan
Blue
Brown
Yellow
Green
Red
Black
Violet