Idiomas disponibles
Idiomas disponibles
��
The tightening of the belt must be repeated each time you buckle up.
EN
7. Check whether the tongue of the impact shield (17) is properly engaged by
pulling on the impact shield (3).
REMOVING AND REATTACHING THE IMPACT SHIELD
As soon as your child is taller than 105 cm or weighs more than 21 kg, the
impact shield (3) must be removed.
To remove the impact shield (3) follow the next steps:
1. Open the buckle of the impact shield (16).
2. Press the belt adjuster release button (14) and undo the belt (13) as much
as possible.
3. Remove the seat cover on the left side of the booster (2) until you can see
the belt fixation point.
4. Press the belt release hook (21) on the fixation point and loosen the metal
bracket (22).
5. Turn the metal bracket (22) so that it can pass through the opening of the
fixation point.
6. Pull the belt of the impact shield (13) completely through the tunnel of the
armrest and through the hole in the seat cover.
��
Note that using the seat without an impact shield is not permitted before
your child reaches a height of at least 100 cm.
Keep the impact shield in a safe and secure place.
��
To reattach the impact shield (3) to the booster (2), follow the steps described
above in reverse order.
Make sure the metal bracket (22) is firmly in place and locked behind the belt
release hook (21).
Make sure that the arrow on the metal bracket and the arrow on the fixation
��
point point to each other.
SECURING THE CHILD WITHOUT IMPACT SHIELD: 100 CM – 150 CM
1. Route the lap belt of the vehicle seat around your child through the green
marked lap belt guides (18) and insert the belt tongue into the belt buckle
of the vehicle. It must lock into place with an audible "CLICK".
2. Tighten the lap belt by pulling on the shoulder belt before inserting the
shoulder belt into the belt guide.
10
3. Insert the shoulder belt and the lap belt together into the lap belt guide (18)
on the side of the vehicle belt buckle.
4. Feed the shoulder belt through the green shoulder belt guide (19) until it
is inside of it.
5. Tighten the shoulder belt by pulling on it.
6. Ensure that the shoulder belt runs across your child's clavicle and does not
touch your child's neck. If necessary, adjust the height of the adjustable
headrest (11) to change the position of the belt.
REMOVING AND REATTACHING THE SEAT COVER
The cover of the car seat consists of four parts (headrest, backrest, booster
and impact shield). These are held in position at several places by press studs
and elastic bands. Once all attachments have been released, the single parts
of the cover can be removed. To remove the booster (2) cover, the impact
shield (3) must be taken off. To do this, please follow the steps in the chapter
"REMOVING AND REATTACHING THE IMPACT SHIELD".
In order to put the covers back on the seat, proceed in reverse order.
The cover may only be washed at 30 °C with a delicate wash program
��
otherwise it may result in discoloration of the cover fabric. Please wash the
cover separately from other laundry and do not dry in the dryer or in direct
sunlight!
MANUFACTURER'S WARRANTY AND DISPOSAL REGULATIONS
CYBEX GmbH (Riedingerstr. 18, 95448 Bayreuth, Germany) gives you
3 years warranty on this product. The warranty is valid in the country, where
this product was initially sold by a retailer to a customer. The contents of the
warranty and all essential information required for the assertion of the warranty
can be found on our homepage
go.cybex-online.com/manufacturer-warranty-car-seats. If a warranty is
shown in the article description, your legal rights against us for defects remain
unaffected.
Please observe the waste disposal regulations in your country.
