Idiomas disponibles
Idiomas disponibles
LZB33-L-AR009-11 ATEX
Product Specific Instructions
Warning
WARNING Polymer hazard
The vanes in this product contain PTFE (a synthetic fluo-
ropolymer). Due to wear, there might be PTFE particles
inside the product. Heated PTFE can produce fumes
which may cause polymer fume fever with flu-like symp-
toms, especially when smoking contaminated tobacco.
Health and Safety recommendations for PTFE must be
followed when handling vanes and other components:
Do not smoke when servicing this product
►
PTFE-particles must not come in contact with open
►
fire, glow or heat
Motor components must be washed with cleaning
►
fluid and not blown clear with an air line
Wash your hands before starting any other activity
►
IP Rating
The IP Rating of the air motors is set under pressurized condi-
tion and excludes the outlet or attached silencer. If the motor
will operate submerged or in heavy water jets, it's recom-
mended to lead the outlet away from water with a hose. When
submerged, always keep the motor pressurized with a higher
pressure than the corresponding depth.
Connecting the air supply
When the compressed air supply is connected to the inlet, the
direction of rotation will be as shown in the figure below. If
the exhaust air is to be piped away, a hose should be con-
nected to the exhaust outlet.
The compressed air supply should be connected to the corre-
sponding inlet for desired rotation direction, see figure below.
The inlet that is not in use, functions as an additional outlet
and must not be plugged.
Installation diagram
Reversible motor
© Atlas Copco Industrial Technique AB - 9836 7193 00
Shaft load diagram
Hot Spots
The following hot spots on the motor can reach high tempera-
tures during operation. The image shows hot spots for specific
models:
• Seal ring at the output shaft (A, B, C)
• Joint between front part and gear ring (A, B)
• Key grip (A, B)
The highest temperatures occur when the motor is running at
full pressure without load. With increasing torque, the air mo-
tor reduces the rotational speed and the temperature.
Warning
Make sure you are familiar with the operating instructions be-
fore you use this motor.
This motor, its attachments and accessories must only be used
for the purpose for which they were designed.
For product liability and safety reasons any modification to
the motor or its accessories, which may have an influence on
the product liability, must be agreed upon by the technical au-
thority of the manufacturer.
Safety Information
5
