Hilti DD 160 Manual De Instrucciones Original página 16

4.5 Gears and corresponding core bit diameters
Gear
1
2
3
5 Preparations at the workplace and starting work
5.1 Securing the diamond core drilling machine to the drill stand
CAUTION
Risk of injury Hazard presented by inadvertent starting of the diamond core drilling machine.
▶ The diamond core drilling machine should not be connected to the power supply during set-up.
1. Remove the end stop screw from the end of the rail.
2. Using the opening provided for the purpose, set the diamond core drilling machine on the rail.
3. Lock the diamond core drilling machine by fully tightening the carriage lock.
4. Check that the diamond core drilling machine is locked by lightly turning the hand wheel.
5. Install the end stop on the rail and check that it is secure.
Check carriage play; adjust if necessary.
5.2 Fitting the hand wheel on the drill stand
The hand wheel may be fitted on the left-hand or on the right-hand side of the carriage.
1. Pull the black ring back to fit the hand wheel.
2. Fit the hand wheel onto the axle.
5.3 Securing the drill stand with an anchor
WARNING
Risk of injury due to use of wrong anchors! The machine can break loose and cause damage.
▶ Use anchors suitable for the material on which you are working and observe the anchor manufacturer's
instructions.
Hilti metal expansion anchors M12 and M16 are usually suitable for use as anchors for diamond core
drilling equipment in uncracked concrete. Under certain conditions, however, it may be necessary
to use an alternative fastening method. Contact Hilti Technical Service if you have questions about
secure fastening.
1. Set an anchor that is suitable for the base material. Select the distance to suit the base plate used.
Technical data
Anchor base plate
Combination base plate
2. Screw the anchor spindle into the anchor.
3. Slip the base plate of the diamond core drilling machine over the spindle and align it.
10 English
Printed: 06.02.2019 | Doc-Nr: PUB / 5069575 / 000 / 05
All manuals and user guides at all-guides.com
Core bit diameter
6.0 in ... 8.0 in
(152 mm ... 202 mm)
2.8 in ... 5.6 in
(72 mm ... 142 mm)
1.0 in ... 2.6 in
(25 mm ... 67 mm)
4
5
Idling speed
460 /min
760 /min
1,690 /min
10.6 in
(270 mm)
11.4 in
(290 mm)
434952
*434952*