Parkside PBK 4 B3 Traducción Del Manual De Instrucción Original página 50

GB MT
Assembly
Disconnect the spark plug
connector (
rying out any work on the
device.
Only use original parts.
The device can be used with either
the hedge trimmer, pruner or trim-
mer attachment, either with the spool or
the 3-tooth blade.
Removal is carried out in reverse
order.
Fitting the middle
tubular shaft
The middle tubular shaft is for use
with the pruner attachment and
hedge trimmer attachment.
1. Loosen the butterfly screw (3).
2. Slide the middle tubular shaft (4) into
the tubular shaft (5) on the device hous-
ing.
3. Turn the middle tubular shaft (4) with a
gentle rotating movement until the but-
ton (10) clicks into place in the hole in
the tubular shaft (5).
4. Fix the middle tubular shaft (4) in place
with the butterfly screw (3).
Tighten the butterfly screw
(3) until no more play is dis-
cernible on the middle tubular shaft
(4)! The use of maximum manual
force will damage the tubular
shaft.
50
73) before car-
Fitting the tubular shaft
If necessary, remove the protective
cap(s) (23) from the front tubular
shaft (2) before assembly.
The front tubular shaft of the
pruner and the hedge trimmer at-
tachment is mounted on the mid-
dle tubular shaft (4).
1. Loosen the butterfly screw (3).
2. Push the front tubular shaft (2) into the
tubular shaft (5) on the device housing
or into the middle tubular shaft (4).
3. Turn the front tubular shaft (2) with a
slight twisting motion until the button
(10) engages in the hole in the tubular
shaft (5) or in the middle tubular shaft
(4).
4. Fix the front tubular shaft (2) in place
with the butterfly screw (3).
Tighten the butterfly screw
(3) until no more play is dis-
cernible on the front tubular shaft
(2)! The use of maximum manual
force will damage the tubular
shaft.
B
Fitting the round handle
For safety reasons, the round
handle (9) may only be fixed
in one of the two positions given
by the hole.
The leg protection must al-
ways be mounted on the op-
erator side!
1. If necessary, loosen the butterfly screw
(38) and put the silver-coloured flap
(39) upright.