Tabla de contenido
Idiomas disponibles
Idiomas disponibles
General safety advice for electrical power tools / Assembly
Damaging a gas pipe can lead to an explo-
sion. Penetration of a water pipe can lead to
property damage or to electric shock.
J
If you use the device outdoors, always
connect it through a residual current
device (rcD) with a maximum trip cur
rent of 30 mA. If using an extension lead, al-
ways use one that is approved for outdoor use.
J
noxIoUS FUMES! Any harmful /
noxious dusts generated from sand-
ing represent a risk to the health of
the person operating the device and to anyone
near the work area.
J
Ensure that there is adequate ventila
tion when working on plastic, paint,
varnish etc.
J
Do not soak the materials or the sur
face you are about to work on with
liquids containing solvents.
Advice on use
Q
Principle of operation:
The oscillating drive causes the attached tool to vi-
brate backwards and forwards up to 21.000 times
per minute. This means the tool can produce precise
work in the tightest of spaces.
Sawing / cutting:
J
Use only undamaged, defect-free saw blades.
Distorted, blunt or otherwise damaged saw
blades could break.
J
When sawing lightweight building materials,
observe the statutory requirements and the
manufacturer's recommendations.
J
Use the device in plunge sawing mode on soft
materials such as wood, gypsum plaster board
etc. only!
Sanding:
J
Ensure that you use even contact pressure. This
will increase sanding sheet life.
30 GB/MT
Assembly
Q
Selecting the right tool
Q
Segment saw blade
11
Materials:
Wood, plastic, non-ferrous metals
Use:
·
Cutting and plunge sawing
·
Close to the edge sawing, even in difficult to
access areas
Example: Parquet including
floor coverings, also with plunge cuts.
Plunge saw blade
7
Materials:
Wood, plastic, plasterboard and other soft materials
Use:
·
Cutting and plunge sawing
·
Close to the edge sawing, even in difficult to
access areas
Example: Sawing of recesses in lightweight walls.
Backing plate
10
Capítulos
Tabla de contenido
