Hilti DX 5 Manual página 39

Malfunction
A cartridge detaches itself
from the cartridge strip.
The cartridge strip cannot be
removed.
7.5 Other malfunctions
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
9 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
10 Confirmation of C.I.P. testing
The following applies to C.I.P. member states outside the EU and EFTA judicial area: The Hilti DX 5 has
been system and type tested. As a result, the tool bears the rectangular PTB approval mark showing
approval number S 995. Hilti thus guarantees compliance with the approved type. Unacceptable defects
or deficiencies, etc. determined during use of the tool must be reported to the person responsible at the
approval authority (PTB) and to the Office of the Permanent International Commission (C.I.P.).
2211871
*2211871*
Printed: 30.05.2018 | Doc-Nr: PUB / 5433084 / 000 / 00
Possible cause
The fastener driving rate is too
high.
Build-up of combustion residues.
Action to be taken
▶ Stop using the tool immediately.
▶ Remove the cartridge strip and
allow the tool to cool.
▶ Service the tool.
English 31