Beem CM5418C-GS Manual De Instrucciones página 33

Idiomas disponibles
  • ES

Idiomas disponibles

33
Preparing Milk Froth
PLEASE NOTE!
The portafilter must be inserted in the device to froth milk!
1. Fill the water tank (15) (see the "Preparation" chapter – "Filling the Water Tank").
2. Make sure that the steam power control (4) is in the OFF position.
3. Switch on the device (see the "Making Espresso" section).
4. Direct the steam nozzle (5) towards the drip tray (10) or into an empty vessel.
5. Press the
button (17) to switch to steam mode. The control lamp
device heats up to a higher temperature. When this is constantly lit, the preheating has
finished and the device is ready to emit steam.
6. Move the steam power control (4) to position
ously from the steam nozzle. The control lamp
7. Turn the steam power control back to the OFF position.
8. Pour milk at fridge temperature with a fat content of at least 2% to a level of roughly two­
thirds into a small milk jug for frothing.
To achieve the best results, we recommend using a small milk jug that is no more than
10 cm tall and has a capacity of 400 ml.
9. Direct the steam nozzle into the small milk jug and immerse it in the milk.
10. Start the frothing process by gradually turning the steam power control to the
position.
11. First hold the steam nozzle just below the surface of the milk to warm it up and draw air
under the milk. Once the milk is warm to the touch and a fine milk froth resembling a
cream is produced, hold the steam nozzle in the middle of the frothing container so that
the milk is swirled around.
12. Once the milk froth is of the desired consistency, turn the steam power control to the
OFF position and pull the frothing container down and outwards.
13. Tap the frothing container one to two times on a solid surface to compress the milk froth.
14. Pour the milk froth into the drinking vessel.
15. Clean the steam nozzle after each use to prevent a blockage (see the "Cleaning and Care"
chapter – "Cleaning the Steam Nozzle").
Empty the drip tray after preparation so that it cannot overflow if you prepare another
drink.
16. Switch off the device (see the "Making Espresso" section).
. Wait until steam emerges continu-
flashes.
EN
flashes and the
loading

Este manual también es adecuado para:

02032