Idiomas disponibles
Idiomas disponibles
EN
Operation and Functions
Operating Buttons
The device has four operating buttons:
Press this button (16) to switch the device on and off.
Press this button (17) to switch to steam mode and adjust the temperature for
producing steam.
Press this button (18) to start / stop the brewing process for a double espresso or
adjust the quantity of water.
Press this button (19) to start / stop the brewing process for a single espresso or adjust
the quantity of water.
The operating buttons have integrated control lamps which indicate by flashing or being lit that
the respective functions are active.
Steam Power Control
The steam power control (4) is used to regulate the emission of steam and hot water:
In this position no steam is emitted.
OFF
In this position steam or hot water is emitted.
When you switch on the device, always make sure that the steam power control is in
the OFF position!
Hotplate
On the hotplate (1) you can preheat your cups or keep espresso that you have made warm.
As soon as the device heats up, the hotplate is automatically heated at the same time.
Setting the Water Quantity
The quantity of water for the single or double espresso can be individually programmed
separately. The range that can be set for the quantity of water is 25 – 60 ml for a single
espresso or 70 – 110 ml for a double espresso.
New settings cancel the factory default settings and are retained even if there is a power
cut or when the device is disconnected from the mains
the factory settings, press and hold the buttons
for approx. 3 seconds until all control lamps flash and a beep is heard.
1. Make sure that the water tank (15) is filled with enough water (see the "Preparation" chapter –
"Filling the Water Tank").
2. Fill the portafilter (9) with espresso powder (see the "Preparation" chapter – "Filling the
Portafilter"). When you do this, note which water setting you want to adjust – single or
double espresso!
power.
To restore the device to
(18) and
(19) simultaneously
28
