Idiomas disponibles
Idiomas disponibles
Replacing the light bulb
! Do not touch the light bulb directly with your hands.
! Do not use the oven lamp as/for ambient lighting.
Troubleshooting
Problem
The "Clock button" and the digits on the
display flash.
A programmed cooking mode does not
start.
Only the high luminosity "Clock button"
is lit.
An automatic mode has been selected.
"Hot" appears on the
display and
cooking does not start.
Fan-assisted cooking has been
selected and the food looks burnt.
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap
G 9.
3. Replace the glass cover (see
diagram).
Possible cause
The appliance has just been connected to the
electricity mains or there has been a blackout.
There has been a blackout.
The appliance is in
standby mode.
The temperature inside the oven is higher
than the suggested value for the selected
mode.
Positions 1 and 5: the direct heat could cause
temperature-sensitive foods to burn.
Sliding rack kit assembly
A
Left
Right guide
guide rail
rail
B
C
D
! Do not place the sliding racks in position 5.
Solution
Set the clock.
Reprogram the cooking mode.
Press any button to exit standby mode.
Wait for the oven to cool down.
We recommend switching dripping pan
positions halfway through cooking.
To assemble the sliding racks:
1. Remove the two frames, lifting
them away from the spacers A (see
figure).
2. Choose which shelf to use with the
sliding rack. Paying attention to the
direction in which the sliding rack is
to be extracted, position joint B and
then joint C on the frame.
3. Secure the two frames with the
guide rails using the holes provided
on the oven walls (see diagram).
The holes for the left frame are
situated at the top, while the holes
for the right frame are at the bottom.
4. Finally, fit the frames on the
spacers A.
31
GB
