TRAPP TR-600 Manual De Instrucciones página 60

Air filter
Motor will not run properly with dirty air filter.
Frequently clean the filter, preferably with
compressed air. See motor manual.
Some problems may occur during the use of the shredder. Find some suggestions to solve them below:
Problem
Shredder jamming Excessive intake/feeding. Organic
Low production
Irregular cut
60
Useful Suggestions
Probable cause
material accumulates inside the
machine.
1. Insufficient feeding.
2. Machine revolution
specification.
3. Humid product.
1. Cutting blades
sharpening.
2. Worn counter cutting blade.
ATTENTION!
TRAPP ORIGINAL
TRAPP does not undertake
responsibility for eventual
damages caused to the
equipment, neither for
accidents that may occur due
to the use of non-original parts.
To clean air pre-filter
The pre-filter must be free from dirt to avoid
damage to the motor due to overheating. Clean
with compressed air or wash in running water
with mild soap.
Solution
Turn shredder off. Remove upper output device,
open cover, remove excess of material from inside
the machine. Close cover, replace output device,
turn shredder on, wait for motor to reach maximum
revolution and get back to work. Control machine
intake/feeding.
1. Maintain
overfeeding which may cause shredder to jam.
below 2. Check whether TDP rpm is below 540 rpm.
3. Shred dry material only; humid products may
block output device.
need 1. Sharpen cutting blades as indicated in "Sharpen
and Replace Blades".
2. Do as item "Check Blades".
Use
! !
PARTS.
www.trapp.com.br
continuous feeding, yet not