TRAPP TR-600 Manual De Instrucciones página 54

Feeding and shredding system
Before starting to work, make sure the machine
has reached maximum speed.
After properly directed the output device,

open the funnel cover.
Select the material to be shredded; do not

exceed maximum cutting length of ø10 cm.
Small branches can be shredded if placed

facing entry.
Do not push small branches with your hands.

Use long pieces of wood to do it. If necessary,
use an adequate device to push the material.
Before inserting the material to be shredded

into funnel, remove different parts of wood
not to damage blades.
Output device adjustment
The direction of the output device jet can be
adjusted and turned 360
jet is adjusted with lever (A); the output position
with arm (B). To move it, loosen screw (C). As the
image below.
54
18
18
. The direction of the
O
Ground transportation
When transporting the machine by road,

follow the traffic code in force.
Storage
If your shredder has not been used for a long
period of time:
1. Clean up it with a damp cloth and mild detergent.
Dry with a clean and dry cloth.
2. Inspect whole equipment, and replace damaged/
worn parts.
3. Firmly tighten all screws and nuts (see table
"Torque Specifications").
4. Lubricate and cover the whole equipment with
canvas. Keep it in a dry place, protected from
weather conditions.
Follow these instructions to always have your
shredder in good working conditions.
Attention!
Do not use a water jet to clean the equipment.
Water in the bearings can damage them.
www.trapp.com.br
A
A
B
C
B
C