TRAPP TR-600 Manual De Instrucciones página 52

Notes:
Do not use the chains to transport or

support cardan transmission when work
is done. Use proper support.
Fit the male and female parts of the

cardan shaft and fit the female side to
the PTO shaft of the TR 5600T and then fit the male cardan shaft to the PTO shaft
of the tractor until the click is heard,
showing that it is in the correct coupling
position on both sides.
After mounting and adjusting the

protection currents, move the hydraulic
inclination of the tractor and check the
clearance between the male and female
gimbal by placing the machine at the
recommended inclination of a maximum
of 15°.
Notice that as the machine moves the

cardan shaft male and female approach
to the point of leaning, if this happens,
turn off the power take off immediately.
Remove the male and female cardan
shaft and re-cut, in order to leave a
minimum clearance of 1 to 2 centimeters
between the cardan shaft tips.
It is not recommended to work with

the male and female cardan shafts
without clearance; this can damage the
tractor and shredder PTO shafts. To
perform maneuvers, remove one of the
cardan shaft parts.After mounting and
adjusting the protection currents, move
the hydraulic inclination of the tractor
and check the clearance between the
male and female gimbal by placing the
machine at the recommended inclination
of a maximum of 15°.
Notice that as the machine moves the

cardan shaft male and female approach
to the point of leaning, if this happens,
turn off the power take off immediately.
Remove the male and female cardan
shaft and re-cut, in order to leave a
minimum clearance of 1 to 2 centimeters
between the cardan shaft tips.
It is not recommended to work with the

male and female cardan shafts without
clearance; this can damage the tractor
and shredder PTO shafts. To perform
maneuvers, remove one of the cardan
shaft parts.
52
Measurement of the cut:
Dividing the measurement found between shafts by 1.3 will
provide the measure to cut the cardan shaft.
Measure between cardan shafts
1.3
Trim plastic
protection
3 cm
Image for illustrative purposes only
Fig. 3
When it is at its maximum opening, the

plastic safety protections and the shafts
must be overlapped by at least 1/3 of its
length.
When in its maximum closing position,

the minimum distance allowed is 1 to
2 cm.
Keep terminals aligned.

Check TDP minimum and maximum length

required to couple the machine/ tractor. In the
event of problems, get in touch with TRAPP
nearest Technical Assistant.
These operations must be made on

adequate floor only. Stop tractor,
disconnect from TDP and use parking
brakes. If necessary, lift the machine
from the ground. For safety reasons,
place it on a support to prevent
accidents.
www.trapp.com.br
= Measure A
Measure the
end of the
cardan shaft