TRAPP TR-600 Manual De Instrucciones página 49

www.trapp.com.br
Assembling output device
Fit output device (1) on shredder cover (2), position
and tighten with butterfly nut (3) and hex-nut (4).
1
2
After that, make sure all machine screws
and nuts are properly tightened (see table
"Torque Specifications").
Installation
Checking battery
Remove closing protection (1) and loosen battery
securing bar (2). Remove battery from base (3),
check for charge.
Note:
3
When replacing battery on the base,

4
make sure to properly connect cables.
Red cable: ( + ) Positive
O
Black cable: (-) Negative
O
Attention!
If equipment is not used for more than

30 (thirty) days, you may run out of
battery.
To prevent corrosion and loss of power

during long storage, disconnect battery
cables.
Disconnected cables must not get in

touch with battery terminals.
13
3
2
1
Image for illustrative purposes only
49