ON
OFF
START
ON
Procedure
1) Remove the top cowling.
2) Remove the flywheel cover by remov-
ing the bolts.
208042
3) Prepare the engine for starting. See
STARTING ENGINE for procedures.
Be sure the engine is in Neutral and
ON
that the lanyard is attached to the
engine stop switch.
The main switch must be on if the
main switch is equipped on the elec-
tric start model.
703043
NOTE:
Prime start model
If the engine will not start with this proce-
dure, refer to "ENGINE FAILS TO OPER-
ATE".
4) To start the engine with emergency
starter rope, insert the knotted end of
the rope into the notch in the flywheel
rotor and wind the rope several turns
208041
clockwise. Then, give a strong pull
straight out to crank the engine.
Repeat if necessary.
5-8
GB
