Tabla de contenido
Automatic
Buttonhole
(BH1)
Stitch pattern: BH1
Thread tension dial: AUTO
Foot: Automatic buttonhole foot R
* When you select the buttonhole stitch, the screen
indicates the message, as shown, for a few seconds.
* The size of a buttonhole is automatically set by placing a
button in the rear of automatic buttonhole foot R.
* The button holder of the foot takes a button size of 3/16"
(0.5 cm) to 1" (2.5 cm)in diameter.
* Make a test buttonhole on an extra piece of the fabric
before actual sewing to check your settings.
* Use interfacing on stretch fabrics.
Sewing
preparation
Attach the automatic buttonhole foot R. Make sure
the groove on the holder catches the pm on the foot
when lowering the presser foot
Groove
Pin
Pull the button holder to the back. and place the
button in it. Push it together tightly on the button.
Button holder
* If the button is extremely thick, make a test button
hole. if it is difficult to fit the button through the test
buttonhole, lengthen by pulling the button holder on
the foot back to increase length.
Button holder
Pull the buttonhole lever down as far as it will go.
Buttonhole lever
Note: if you start sewing without pulling down the
buttonhole lever, the screen will show a warning
message.
BHI
H
I
i
i
i
\
76
Tabla de contenido
