SECTION
IV. DECORATIVE
STITCHING
Pintucking
(_ Stitch pattern: #1 (mode 1)
@ Thread tension dial: AUTO
(_ Foot: Blind hem foot G
Place the folded fabric under the raised presser foot.
Lower the needle into the fabric 1/16" (0.1 to 0.2 cm) from
the folded edge, Lower the presser foot, Turn the screw to
adjust the guide on the blind hem foot to touch the folded
fabric edge,
Feed the folded edge smoothly against the guide.
After sewing is finished, use an iron to make pleats,
®
Quilting
(_ Stitch pattern: #1 (mode 1_
G Thread tension dial: AUTO
(_ Foot: Zigzag foot A
@ Quilter
Note:
When using the straight stitch foot. make sure to use
center needle position.
Otherwise the needle may
strike the sewing foot and possibly break.
r_
[] The quilter will keep the stitching lines straight.
Loosen
the quilter screw, Slide the quilter in the opening to the
desired width and tighten the screw,
[] Sew guiding the quilter over the previous row of
stitches,
(_ Quilter holding screw
(_ Quilter
(_ Hole
(_ Distance
[]
[]
/
98