Idiomas disponibles
Idiomas disponibles
EN
Confirm with the "MR" button.
The cursor is positioned at the left side of the enter
line.
Select the desired characters with the "O" or "U"
button.
To move the cursor to the next position, press the
"R" button.
Select the next character.
Repeat the previous steps until the text "Bolt B"
has been entered.
Confirm the input with the "MR" button.
The adjusting parameters is now stored. In this way,
the data for the first wrenching operation is complete
The menu "adjusting operations" can now be scanned
using the "O" or "U" buttons. This now contains the
newly-inputted adjusting parameters "Bolt B".
Repeat the previous operating steps and enter a
second adjusting parameters with the values from
"Bolt B" and name the second adjusting parameters
"Bolt C".
Enter a third wrenching operation with the following
values:
Mode: Torque
Torque (30)
Tolerance (5)
Pre-warning [%] (80)
Adaptor length (remains unchanged for now)
unit (N·m)
Name (Bolt A)
Select the item "define new parameters" with the
"O" or "U" button.
Confirm with the "MR" button.
Input of a define process
A define process is a collection of adjusting
operations, which are carried out in a preset order.
After the adjusting operations have been inputted, a
define process can be set up
In the "define process" menu
new define process can be set up,
viewed or deleted
If a certain order of wrenching operations is not
necessary, then no define process needs to be set
up. The stored adjusting operations can be
directly selected as well.
Select the item "define processs" in the main
menu using the "O" or "U" button.
Confirm with the "MR" button.
You are now in the "define process" sub-menu.
On the display panel a list with all stored adjusting
operations is shown.
To input a define process, confirm with the "MR"
button.
On the display panel a list with all stored wrenching
operations is shown.
Select the adjusting parameters "Bolt A" using the
"O" or "U" button.
To add adjusting parameters to an define process,
press the "MR" button once .
Take care not to press the "MR" button twice.
Otherwise the selected adjusting parameters will
be added a second time.
The input is confirmed acoustically (buzzer) and by the
green LED briefly lighting up.
The adjusting parameters selected is now the first
operation in the define process.
Now add the adjusting operations "Bolt C" and
"Bolt B" using the "O", "U" and "MR" buttons.
Name the define process "Example".
ATTENTION
Settings for the sequence plan are not stored.
Always complete the input of a sequence plan
by assigning a name.
When a name has been given to a define process,
no further adjusting operations can be added to
this define process.
To leave the menu, press the "ML" button twice.
Operating the torque
wrench
How to set tightening operations and define
processes can be found in the chapter entitled
"Inputting data for wrenching processes" (see
page 12 ) in the practical examples.
DANGER
Danger of severe or fatal injuries due to
incorrect measured values.
Make sure that the torque value is set
correctly prior to use.
Make sure that the insert and/or plug-in
tool that is used is seated securely prior
to use.
ATTENTION
Damage to the torque wrench
The torque wrench must not be overloaded.
Always observe the maximum torque which can
be set (see type plate).
Ascertaining the tare of the wrench
In order to guarantee exact readings, the wrench tare
must be ascertained for each adjusting parameters.
This procedure is different for the 712R/6 and 713R
models.
13
