Idiomas disponibles
Idiomas disponibles
7. Getting started
7.1. Unpacking and setting up
Place the device on a sturdy, level surface. Take care to ensure the following:
•
the device is not exposed to intense sources of heat;
•
the device is not exposed to direct sunlight;
•
the device does not come into contact with liquids, not even water droplets or
spray.
Unplug the device's mains plug before connecting a device.
7.2. Inserting/replacing batteries in the remote
control
Insert the 1.5 V AAA battery in the remote control.
Open the battery compartment cover.
Insert the battery so that the negative pole contacts the springs.
Replace the battery compartment cover.
WARNING!
Risk of explosion if batteries are replaced incorrectly.
Replace batteries only with the same or equivalent
type.
7.3. Connecting the loudspeakers
Ensure that your device is not connected to the mains power supply.
Plug the speaker cables into the correct, corresponding sockets on the rear of
the Micro Audio System. R (right) for the right loudspeaker, L (left) for the left
loudspeaker.
7.4. Antenna connection
To receive radio signals, connect the wire antenna to the FM ANTENNA con-
nection socket on the device and move it until you get the best reception.
54
