Holes For Cables; How To Replace The Magnesium Anode - Olimpia splendid SHERPA SHW S1 200 Manual Del Usuario

POS.
1
2
3
4
5
6
7 Upper tank temperature (T3) + thermostat T85°C
8
9 1200 W auxiliary electric heater with integrated thermostat
10
11
12
13
14
15
16
17
18
19

8.3 HOLES FOR CABLES

8.4 HOW TO REPLACE THE MAGNESIUM ANODE

The Magnesium anode is an anti-corrosion element. It is assembled in the water tank to avoid the creation of fur coat inside the
tank in order to protect it, and the other components. It can help to extend the life-span of the tank.
Check the magnesium anode every 6 months and change it if it has the diameter less than 22 mm, clean it if it is
intact but encrusted by limestone.
Turn the power of the unit 'OFF' and pull out the plug.
•
• Drain all the water out of the tank.
• Remove the old magnesium stick from the tank.
Replace the new magnesium stick.
•
• Recharge the water.
12
DESCRIPTIONS
Aluminium heat exchanger
Hole for auxiliary cables
Hole for power supply
Condensate drain
Hot water outlet
Anti-corrosion magnesium anode
Connection for re-circulated water
Grounding
Lower tank temperature (T2)
Cold water inlet
Solar water outlet
Auxiliary tank temperature
Solar water inlet
Solar exchanger serpentine
Auxiliary heat source outlet
Auxiliary heat source inlet
Auxiliary heat source serpentine
DIMENSIONS
200 SERIES
3/8"
φ 17 mm
φ 17 mm
φ 22 mm x 0,3 m
G 1" female
1" ¼ female
φ 12 mm x L 120 mm φ 12 mm x L 120 mm
G ½" female
1" ¼ female
M6
φ 12 mm x L 90 mm
φ 12 mm x L 90 mm
G 1" female
G 1" female
φ 12 mm x L 90 mm
/
G 1" female
1,2 m 2
G 1" female
G 1" female
0,5 m
2
300 SERIES
3/8"
φ 17 mm
φ 17 mm
φ 22 mm x 0,3 m
G 1" female
1" ¼ f female
G ½" female
1" ¼ female
M6
G 1" female
G 1" female
G 1" female
1,2 m 2
G 1" female
G 1" female
0,8 m
2