Operation; Notes On Operation - Bosch Rexroth KU 1 Instrucciones De Montaje

30/38 Bosch Rexroth AG
8

Operation

CAUTION
Hot electric motor surfaces during operation!
Possible burns if the hot surfaces (over 65°C) are touched

Provide appropriate safety devices to seal off the motors.

Let the system cool off for at least 30 min. before performing any
maintenance or repair work.
NOTE
Malfunctions due to additional load
There is a tendency to place objects on covers or protective hoods at
curve KU 1. The additional load can cause lowering of curve KU 1.
A displacement of the curve leads to malfunctions.

Provide ground support for covers or protective hoods in addition to
fastening at curve KU 1.
8.1

Notes on operation

8.1.1 Wear
• Wear is caused by the basic principle of this system and cannot be
avoided. Constructive measures and selection of the proper materials will
help functional safety last for the lifetime of the system. However, wear
depends on the operating, maintenance, and ambient conditions of the
system, as well as the location (resistance, contamination).
• Overloading the conveyor sections may damage the conveying medium
and cause the motor and gears to fail.
• Function cannot be guaranteed if the pneumatic components are
overloaded.
8.1.2 Measures to reduce wear
The following measures reduce wear:
• Switch off conveyor sections when the system is not running,
e.g. during breaks, over night, on the weekend.
• Only select speeds that correspond with the particular function.
• Especially important: Avoid contamination by abrasive media; reduce
contamination through regular cleaning.
TS 1 | 3 842 531 106/2013-04