Parameterizing The Lubrication Unit For Operation; Re-Commissioning After A Standstill - Bosch rexroth LU 2/P Instrucciones De Montaje

9.1.3

Parameterizing the lubrication unit for operation

Deviating from the factory settings of the lubrication unit, only the parameter
PausedBy must be changed.
For operation on Rexroth TS 2 transfer systemsplus the following parameters are
recommended:
• CYCLE END on Cycle (default)
• LUBE type on 33V/PS (default)
• PauseBy on counter
Default Timer; changeover to start of the lubrication phase by a pulse at the
counter input (see chapter 8.5.9).
• CYCLE Tout on 30s (default)
• LUBE Cycles on 1 (default)
• START IN on RESUME (default)
• PRELUBE on 0 (default)
• DELAY Time on 5s (default)
• SUSPEND on DISABLE (default)
• Pause Cnt on 1 (default)
9.2 Re-commissioning after a standstill
Follow the steps outlined for the initial commissioning.
3 842 557 976/2020-08, MIT: LU 2/P-24V-3L, Bosch Rexroth AG
Commissioning 35/42