Start-Up; Operation; Manually Adjusting The Table Height - Bosch rexroth 3 842 998 350 Manual De Instrucciones

64/78

Start-up

Bosch Rexroth AG, MPS: HEAP, 3 842 555 612/2019-01
9 Start-up
Function of the control unit only in conjunction with contact bridge or collision
protection.

10 Operation

Colliding with obstacles
The height-adjustable workstation can be damaged, shortening its service life.
„ Keep the movement area below the table top clear.

10.1 Manually adjusting the table height

Fig. 47: Manually adjusting the table height
Move downwards with the "DOWN" (A) button
„
Move upwards with the "UP" (B) button
„
The display (C) shows the correct working height in cm if the minimum working
height has been set to 720 mm (see chapter 8.4).
• The lift modules move down and up at normal speed as long as the button is
held down. Before reaching the mechanical end position, the machine stops
automatically.
• If the lifting modules move downwards, they stop automatically about 100 mm
before reaching the end position. If you press button "A" once again, the lifting
modules continue to travel at reduced speed to the lower end position (clamping
protection).
If you want to move downwards within the safety zone and the last movement
was upwards, press the "DOWN" button twice.
NOTICE
A B
C
555 612 -43