Troubleshooting - Yamaha CD-S2100 Manual De Instrucciones

Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or
if the instructions below do not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
Problem
The power cable is not connected nor completely
This unit fails to turn
connected.
on.
The automatic standby function is activated.
This unit
automatically goes to
STANDBY mode.
A foreign object is obstructing the tray.
The disc tray does not
close completely.
The disc is damaged.
Playback does not
start.
There is moisture on the laser pickup.
The disc is loaded upside down.
The disc is dirty.
The MP3 or WMA formats are not compatible
with this unit.
The CD-RW (ReWritable) disc is not recorded
correctly.
The disc is a non-standard disc not playable with
this unit.
The disc may be scratched or damaged.
Playback is delayed,
or begins at the
wrong place.
Improper output cable connections.
No sound.
Improper amplifier operation.
The unit is in PURE DIRECT mode.
No playback sound
from the component
The Super Audio CD layer is being played.
connected to the
digital input jacks.
This unit is being subjected to vibrations or
Sound "skips."
impacts.
The disc is dirty.
The clock of the playback audio signal is
fluctuated.
Improper cable connections.
Sound "hums."
Cause
Securely connect the power cable.
If the unit is not operated for 30 minutes with no
audio signal detected, it automatically goes to
STANDBY mode.
Carefully check the disc tray and remove the
foreign object.
Check the disc carefully; replace it if necessary.
Wait 20 to 30 minutes after switching the unit
ON before trying to play back a disc.
Reload the disc with the label side up.
Clean the disc.
Replace the disc with a correctly recorded disc
playable with this unit.
Replace the disc with a correctly recorded disc
playable with this unit.
Replace the disc with a correctly recorded disc
playable with this unit.
Check the disc carefully; replace it if necessary.
Connect the cables properly. If the problem
persists, the cables may be defective.
Set the amplifier controls to the correct input
selection.
Turn off PURE DIRECT mode.
Change the layer for playback.
Relocate this unit.
Clean the disc.
Change the DPLL bandwidth of the audio DAC
(ES9016).
Securely connect the audio cables. If the problem
persists, the cables may be defective.

Troubleshooting

Remedy
See
page
20
6
—
—
—
—
28
28
27
27
28
18
—
7
7
—
28
15
18
29
En