Pet Fountain Reassembly - Petsafe Aqua Fountain MWW19-15763 Manual De Instrucciones

Pet Fountain Reassembly

1. Check the flow control on the Pump. Make sure it is in the desired flow rate
position (Fig. 13 & 14).
Fig. 13
2. Place the Pump inside the Bowl's square indention with the Pump tube positioned
in the back left corner (Fig. 15).
3. Make sure the In-Line Plug is disconnected from the Adaptor. With the Pump in
place, pass the cord through the hole in the rim of the Bowl. Feed the cord all the
way through and push the Rubber Grommet into place to seal the hole. Be sure to
leave enough slack in the cord so the Pump rests flat (Fig. 16).
Fig. 15
4. Replace the filter Housing by lowering it straight down over the Pump. Be sure the
Housing clips align with the guide holes on the rim of Bowl. Push down to lock
into place (Fig. 17 & 18).
Fig. 17
12
Minimum
Fig. 16
www.aquapetfountain.com
Fig. 14
Maximum
Fig. 18
Rubber Grommet