Pet Fountain Reassembly - Petsafe Drinkwell D360-CA-17 Manual De Funcionamiento

5. Once the Pump is disassembled you can clean the parts with
warm soap and water. Use a cotton swab or the "motor"
brush from the Drinkwell
motor cavity and remove any build-up (Fig. 20). For added
disinfecting and hard water removal, clean the Pump's motor
cavity with a diluted vinegar solution (20% white vinegar &
80% water). Be sure to rinse thoroughly with fresh water.
6. Once the parts are clean you can reassemble the Pump for use.
a) Replace the Impeller.
b) Replace the Intake Plate.
c) Replace the Faceplate.

Pet Fountain Reassembly

1. Place the Foam Filter around the Pump. Make sure the electrical Power Cord runs
over the top of the Foam Filter, not underneath it, as this will keep the Foam Filter
in place.
2. With the Foam Filter securely around the Pump, replace the Pump into its location
between the four posts in the centre of the Bowl. Be sure to position the circular
opening on the top of the Pump next to the Cord Pass-
Through in the Bowl. Gently push down to engage the
suction cups.
3. Replace the Intake Tube into the Intake Tube Holder, then
place the Intake Tube Holder back onto the Cord Pass-
Through aligning the guideline on the post with the notch in
the Intake Tube holder. Be careful to align the Intake Tube
so that it fits into the circular opening on the top of
the Pump.
4. Thread the In-Line Plug through the Cord Pass-Through next to
the Pump (Fig. 21). On the bottom side of the Bowl, clip the
electrical Power Cord into place using the Cord Clips
(Fig. 22). Next, guide the electrical Power Cord through the
Notch in the side of the Bowl (Fig. 23 & 24).
12
Cleaning Kit to get into the Pump's
®
Notch
Fig. 24
Fig. 23
www.petsafe.net
Fig. 20
Fig. 21
Notch
Fig. 22
Cord Clips