Pet Fountain Reassembly - Petsafe Aqua Fountain Cube Manual De Instrucciones

Pet Fountain Reassembly

1. Check the flow control on the Pump. Make sure it is in the desired flow rate
position (Fig. 15 & 16).
Fig. 15
2. Place the Pump into the Bowl between the Pump placement guides (Fig. 17). Be
sure the Pump is placed with the Output Tube toward the left side, when looking
at the Pet Fountain from the front (Fig. 18). If the Pump is installed incorrectly, it
will not allow the Housing to attach properly. If this is the case, simply turn the
Pump around.
Fig. 17
3. With the Pump in place, the electrical power cord on the Pump should be aligned
with the Cord Notch at the top of the Cord-Pass-Through tube. Make sure the In-
Line Plug is disconnected. Feed the In-Line Plug through the opening and be sure
to place the electrical power cord in between the Cord Notch (Fig. 19).
12
Minimum
www.aquapetfountain.com
Fig. 16
Maximum
Fig. 18
Output Tube