Miter Cutting; Bevel Cut; Compound Cutting - Makita LS1018 Manual De Instrucciones

3. Miter cutting

Refer to the previously covered "Adjusting the
miter angle".

4. Bevel cut

Loosen the lever and tilt the saw blade to set
the bevel angle (Refer to the previously covered
"Adjusting the bevel angle"). Be sure to retighten the
lever firmly to secure the selected bevel angle safely.
Secure the workpiece with a vise. Make sure the car-
riage is pulled all the way back toward the operator.
Switch on the tool without the blade making any con-
tact and wait until the blade attains full speed. Then
gently lower the handle to the fully lowered position
while applying pressure in parallel with the blade
and PUSH THE CARRIAGE TOWARD THE GUIDE
FENCE TO CUT THE WORKPIECE. When the cut is
completed, switch off the tool and WAIT UNTIL THE
BLADE HAS COME TO A COMPLETE STOP before
returning the blade to its fully elevated position.
WARNING:
• After setting the blade for a bevel cut, before
operating the tool ensure that the carriage
and blade will have free travel through-
out the entire range of the intended cut.
Interruption of the carriage or blade travel during
the cutting operation may result in kickback and
serious personal injury.
While making a bevel cut keep hands out of
•
the path of the blade. The angle of the blade
may confuse the operator as to the actual blade path while cutting and contact with the blade will
result in serious personal injury.
• The blade should not be raised until it has
come to a complete stop. During a bevel cut
the piece cut off may come to rest against the
blade. If the blade is raised while it is rotating
the cut-off piece maybe ejected by the blade
causing the material to fragment which may
result in serious personal injury.
NOTICE:
• When pressing down the handle, apply pressure
in parallel with the blade. If a force is applied
perpendicularly to the turn base or if the pressure
direction is changed during a cut, the precision of
the cut will be impaired.
• Before bevel-cutting, an adjustment of the sliding
fence may be required. Refer to the section titled
"Guide fence adjustment".
CAUTION:
• Always remove the sub-fence R so that it does
not interfere any part of the carriage when per-
forming right bevel cuts.

5. Compound cutting

Compound cutting is the process in which a bevel
angle is made at the same time in which a miter
angle is being cut on a workpiece. Compound
cutting can be performed at the angle shown in
the table.
Miter angle
Left and Right 0 - 45
When performing compound cutting, refer to
"Press cutting", "Slide cutting", "Miter cutting" and
"Bevel cut" explanations.
6. Cutting crown and cove moldings
Crown and cove moldings can be cut on a com-
pound miter saw with the moldings laid flat on the
turn base.
There are two common types of crown moldings
and one type of cove moldings; 52/38° wall angle
crown molding, 45° wall angle crown molding and
45° wall angle cove molding. See illustrations.
1
► 1 . 52/38° type crown molding 2. 45° type crown
molding 3. 45° type cove molding
There are crown and cove molding joints which
are made to fit "Inside" 90° corners ((1) and (2) in
Fig. A) and "Outside" 90° corners ((3) and (4) in
Fig. A).
(1) (2) (3) (4)
Fig.A
1. Inside corner 2. Outside corner
17 ENGLISH
Bevel angle
Left and Right 0 - 45
2
1 2
3