Special Functions; Program Selection; Pump Settings V1 - Ferroli ECOTRONIC HiTech Manual Del Usuario

ECOTRONIC HiTech

6. SPECIAL FuNCTIONS

Exit special functions

6.1.Program selection

6.2.Pump settings V1

The settings in this menu should only be changed by appropriate personnel.
6.1 Program selection
The desired hydraulic variant for the specific application is selected and set here.
Program selection normally occurs only once during the first putting into service
by personnel in charge. Wrong program selection can result in unexpected errors.
6.2 Pump settings V1
This menu contains the settings for the 0-10V or PWM pump.
When this menu is selected, there may be a prompt to save the speed settings.
Pump Type
The type of device to be controlled is set here.
0-10V: Controlled by a 0-10V signal.
PWM: Control by a PWM signal.
Pump Profile
In this menu, it is possible to select the preset profiles for the pump or do all the settings in
"Manual". Individual settings can still be changed after a profile has been selected.
Output signal
This menu determines the type of pump: the heating pumps work at their maximum power
with a small input signal; solar pumps, on the other hand, work at the minimum flow rate with
a small input signal. Solar = normal, heating = inverted. For the 0-10 V pump, always choose
the "Normal" setting
Used to set basic elements and extended
functions.
OK
code 3542A420 - Rev. 00 - 12/2021
EN 159