Measurement Values; Statistics; Operating Hours - Ferroli ECOTRONIC HiTech Manual Del Usuario

1. MEASuREMENT VALuES

Exit measurements
1.1.S1 Collector
1.2.S2 Storage
If an error is displayed on the screen instead of the measurement value, there may
be a faulty or incorrect temperature sensor.
If the cables are too long or the sensors are not positioned correctly, there may
be small inaccuracies in the measurement values. In this case, the values on the
display can be compensated by adjustments in the controller (see "6.11 Probe
calibration" on page 174). The selected program, the connected sensors and the
specific model design determine the displayed measurement values.

2. STATISTICS

Exit statistics

2.1.Operating hours

2.2.Heat quantity
For time-dependent functions, such as circulation and anti-legionella and the eval-
uation of system data, the time must be accurately set on the controller. Note that
the clock continues to work for about 24 hours in case of a power outage, after
which it must be reset. An improper setting or an incorrect time can cause deletion,
incorrect storage or overwriting of data. The manufacturer declines any liability for
the stored data.
2.1 Operating hours
Shows the hours of operation of consumer devices connected to the controller (e.g. solar
pumps, valves, etc.); various time intervals (day-year) are available!
152 EN
Display of current measured temperatures.
49°C
23°C
Used as a control function and for long-term
system monitoring.
OK
code 3542A420 - Rev. 00 - 12/2021
ECOTRONIC HiTech