Electric Starting (Option) - AL-KO T15-105.6 Hd-A Manual De Instrucciones

The motor has a fixed speed setting.
A speed regulation is not possible.
Without speed remote control, with primer (
1. Press the primer button 3x, at intervals of approx.
2 seconds (
16). At temperatures below 10 °C,
press the primer button 5x.
2. Pull the safety bar to the upper bar and hold (
17) – safety bar does not engage.
3. Pull the starter cord quickly and allow it to slowly
coil up again (
18).
The motor has a fixed speed setting.
A speed regulation is not possible.
Without speed remote control, without primer/choke
1. Pull the safety bar to the upper bar and hold (
17) – safety bar does not engage.
2. Pull the starter cord quickly and allow it to slowly
coil up again (
18).
The motor has a fixed speed setting.
A speed regulation is not possible.
With speed remote control, with choke
Speed remote
control, with choke
1. Set speed lever to position
2. Pull the safety bar to the upper bar and hold (
17) – safety bar does not engage.
3. Pull the starter cord quickly and allow it to slowly
coil up again (
18).
4. After the motor has warmed up (approx. 15-20
seconds) set the gas lever to a position between
and (
14/2).
16)
(
14/1).
With speed remote control, without primer/choke
Speed remote
control
Start Stop
1. Set speed lever to position
2. Pull the safety bar to the upper bar and hold (
17) - safety bar does not engage.
3. Pull the starter cord quickly and allow it to slowly
coil up again (
18).
4. After the motor has warmed up (approx. 15-20
seconds) set the speed lever to a position between
and (
20).
With speed remote control, with primer (
Speed remote
control
Start Stop
1. Set speed lever to position
2. Press the primer button 3x, at intervals of approx.
2 seconds (
16). At temperatures below 10 °C,
press the primer button 5x.
3. Pull the safety bar to the upper bar and hold (
17) - safety bar does not engage.
4. Pull the starter cord quickly and allow it to slowly
coil up again ( 18).
5. As soon as the motor is running, set the speed
lever for the desired motor speed to a position
between and

Electric starting (option)

Electric start with primer (
1. Set gas lever to position "START" (
2. Press the primer button 3x, at intervals of approx.
2 seconds (
16). At temperatures below 10 °C,
press the primer button 5x.
3. Pull the safety bar to the upper bar and hold (
17) – safety bar does not engage.
4. Turn ignition key in ignition switch to the right
completely (
19).
GB
(
20/1).
16)
(
20/1).
(
20).
16)
15/1).*
29