Starting The Motor - AL-KO T15-105.6 Hd-A Manual De Instrucciones

GB
Inserting the side discharge
1. Remove the grass catcher and insert the mulch kit.
2. Fold open the cover for the side discharge and hold
firmly (
11/1).
3. Insert the side discharge chute (
4. Slowly close the cover.
The cover secures the side discharge channel from
falling out.
Removing the side discharge
1. Fold open the cover for the side discharge and hold
firmly (
11/1).
2. Remove the side discharge and close the cover (
11/2).
Working height adjustment (option)
The working height can be adjusted to two different
heights, if needed.
1. Screw off both handle screws on the handle bar
fitting.
2. Pull out the threaded bolts and adjust to the desired
position by inserting into one of the two square
holes on the holders and through the bars (
Make sure that the same hole is used on each of
the holders!
3. Tighten the holders with the lower bar again using
the handle screws.

Starting the motor

Danger - risk of poisoning!
Never run the motor in enclosed spaces.
Danger - risk of injury!
Do not tip the unit during the starting procedure.
▪ Only start the motor with mounted blade (the
blade serves as centrifugal mass)
▪ When starting the warmed motor, do NOT use
the (HONDA) choke or primer button
▪ Do not modify the control settings on the motor
28
„ Do not start the unit if the discharge chute is not
„ Operate the starter switch with particular care ac-
11/2).
„ Make sure your feet are at a sufficient distance
„ Start the unit in low grass
Position indicators on the unit:
Choke*
Start Run
Speed remote
control*
Start
Speed remote
control, with
choke*
Vario gearbox*
Fast Slow
Blade clutch*
On
12).
*depending on version
Manual starting
Without speed remote control, with choke
Choke
Start Run
1. Set choke to position 1 (
2. Pull the safety bar to the upper bar and hold (
3. Pull the starter cord quickly and allow it to slowly
4. After the motor has warmed up (approx. 15-20
covered by one of the following parts:
Grass catcher
„
Baffle plate
„
Mulch kit
„
cording to the manufacturer instructions
away from the cutter unit.
Stop
Off
17) – safety bar does not engage.
coil up again (
18).
seconds), set the choke position 2 (
Translation of the original operating instructions
Petrol lawn mower
13/1).
13/2).