AL-KO T15-105.6 Hd-A Manual De Instrucciones página 27

Central axle adjustment
1. Place both thumbs on the ends of the axle.
2. Place fingers under the motor housing.
3. Using both thumbs, pull the axle out of the previous
notch for the cutting height.
4. Using both thumbs, pull the axle in front of the
desired notch and allow it to engage.
5. Make sure all wheels engage at the same position.
Mowing with grass catcher
Danger - risk of injury!
Remove or replace the grass catcher only while
the motor is switched off and the cutting blade
has stopped.
1. Lift up the baffle plate and hang the grass catcher
into the holders. (
Fill level indicator
The level indicator is pressed upwards by the air stream
during mowing (
7a).
If the grass catcher is full, the level indicator lies flat on
the box ( 7b). The grass catcher needs to be emptied.
Emptying the grass catcher
1. Lift the baffle plate.
2. Unhook the grass catcher and remove it to the rear
(
8).
3. Entity the grass catcher.
4. Lift up the baffle plate and hang the grass catcher
into the holders (
Mowing with grass catcher
Attention!
Only mow without grass catcher if the torsion
spring of the baffle plate is functional.
The baffle plate lies on the lawn mower housing by
means of spring force. The grass clippings are thus dis-
charged towards the rear.
( 6)
8).
8).
Mulching with the mulching kit (op-
tion)
With mulching, the cuttings are not collected and remain
on the grass. The mulch protects the ground from drying
out and provides it with nutrients.
The best results are achieved by regular cutting of ap-
prox. 2 cm. Only young grass with soft blades will decom-
pose quickly.
„ Height of grass before mulching:
mum 8 cm
„ Height of grass after mulching: Minimum 4 cm
Adapt your walking speed to the mulching and do
not go too quickly.
Utilising the mulch kit
Danger - risk of injury!
Remove or insert the mulch kit only while the
motor is switched off and the cutting blade has
stopped.
1. Remove the grass catcher (
2. Lift up the baffle plate and insert the mulch kit into
the discharge chute (
The locking mechanism must engage.
If the mulch kit does not engage, the mulch kit
and cutting blade can be damaged.
Removing the mulch kit
1. Lift the baffle plate.
2. Release the locking mechanism on the mulch kit (
10/1).
3. Pull out the mulch kit (
Mowing with side discharge (option)
Danger - risk of injury!
Remove or replace the side discharge only while
the motor is switched off and the cutting blade
has stopped.
GB
Maxi-
8).
9).
10/2).
27