Desoutter AFTE270 Serie Manual Del Usuario página 7

@
Z>e4fJ'UUAK.
'
TM
WARNING:
'
.
(2)
(3)
(4)
ENSURE THAT NO LOOSE ARTICl.ES OF
CLOTHING, LOOSE HAIR OR CLEANING
MATERIAL CAN BE CAUGHT BY THE
MOVING PARTS OF THE TOOL
ALWAYS ALLOW THE TOOL
TO
STOP
BEFORE REMOVING THE WORK.
ENSURE THAT THE WORK PIECE IS
SECURELY CLAMPED BEFORE
COMMENCEMENT OF OPERATION.
(5) CLEAR ALL LOOSE ITEMS FROM
VICINITY.
(6)
(7)
(B)
(9)
(10)
(11)
(12)
&
ENSURE THAT THE TOOL
IS
SECURELY
MOUNTED BEFORE COMMENCEMENT
OF OPERATION.
ENSURE THAT BOTH GUARDS ARE
FITTED.
BEWARE OF TOOL OUTPUT. THIS
ADVANCES AND ROTATES.
EYE PROTECTION MUST BE WORN
WHEN OPERATING THE TOOL
DO NOT OPERATE THE TOOL IN
EXPLOSIVE ATMOSPHERES.
WHEN MACHI NG HAZARDOUS
MATERIALS, PROVISION MUST BE
MADE FOR DUST COLLECTION OR
SUPPRESSION.
ENSURE THAT AN EMERGENCY STOP
IS PROVIDED FOR THE TOOL,
WHETHER USED ALONE OR BUILTINTO
A MACHINE.
~nn1ed
In England
®
Stroke Adjustment
&
3
2
FIGURE 4 smoKE ADJUSTMENT
Set lhe gap bctwcon (2) and (3) to equal tho depth of
tapping required PLUS lhe distance the bit Is above the
work piece, by ofidlng (4). Make sure (B) lo over (1), (LED
will illuminate) and lock Into position with (S) to tho
recommended torque. Loosen (7) and tum (6) for fine
adjustment Ensure covers are refttted.
CYCLE CHECK
WARNING: (1) DO NOT CLAMP THE TOOL OUTSIOE OF
THE AREA OF THE BLACK OUTER CASE.
(2) ENSURE SAFETY GUARDS ARE FITTED TO
AVOID CRUSHING FINGERS AND TO
PREVENT LOOSE CLOTHING BEING
CAUGHT IN MOVING PARTS.
Ensure that the emergency stop butlon is released. Switch on tho
power supply and press Die start button, The tool should rotate the
lead screw to advance until the stroke Bdjusllng screw actuales the
depth proximity switch. The motor should stop and then reverse to
rotum the tool to the datum position. When at datum the motor
should switch off.
IMPORTANT: Upon setting up of the tool H Is advisable to carry out
a sor1es or trial runs lo ensure the tapping depth Is
acceptable.
7
of 55
Changing of Lead.screw
&
Advance the tool lrom l's datum po:1itlon to
approximately hBlf the depth of the lead acrew.
Releaae the grutrscrows (1). Pull the toot forward
using the quill which
win release lhe leadscrew from
the output shaft (2). Rolea38 screw on tho cross hoed
(3) and slide the cross head back (towards lhe datum
position). The leadscrew can now be removed.
Replacement lS the reversal of the above. Ensure
eovors are refined.
2
·-"""' .
""'
\
~
~
FIGURE
5
CHANGING
THE
LEADSCREW
Part No. 441573 Issue 3 03 99
'
i·
'