Environmental Protection - AL-KO Solo R13-72.5 HD Manual De Instrucciones

en
Fault
Mower mechanism does not
engage, or continues to run on
when switched off. Ignition key
is in position I (DRIVE).
Uneven travel, low traction on
a slope, or surging of the ma-
chine. Ignition key is in position
I (DRIVE).
Unusual vibrations during ope-
ration. Ignition key is in position
I (DRIVE).

ENVIRONMENTAL PROTECTION

Environmental protection is a relevant and pa-
ramount aspect of the use of this machine, and
benefits good neighbourliness and our habitat
equally.
Disturb your neighbours as little as possible.
Comply with the local provisions relating to
the disposal of the cut vegetation.
Comply with the local provisions relating to
the disposal of packaging material, spent oil,
fuel, filters, defective components or those
which are seriously polluting. These wastes
do not belong with normal household refuse,
but must instead be separated and sorted,
and sent to the appropriate material disposal
points for subsequent recycling.
58
Possible cause
Travel speed is too high relative
to the cutting height.
Engine speed too slow.
Mower mechanism is blocked
with grass.
Problems when engaging the
electromagnetic clutch.
Drive belt tension is not correct. Contact an authorised service
Transmission problems.
Problems with the mower me-
chanism.
Attachment bolts are loose.
Mower mechanism is blocked
with grass.
Scrapping and disposal
Do not dispose of the disused machine into the
environment; instead, contact a collection point.
A large part of the materials used in the manufac-
ture of the machine can be recycled. All metals
(steel, aluminium, brass) can be sent to a scrap
metal dealer. For further related information, con-
tact the responsible communal organisation. The
wastes arising from the scrapping of the machine
are to be disposed of in compliance with the app-
licable environmental laws.
In all cases comply with the applicable local regu-
lations.
Environmental protection
Remedy
Reduce travel speed or raise
mower mechanism.
Contact an authorised service
workshop.
Remove the grass sack.
Clean the grass discharge
channel.
Clean the inner area of the
mower mechanism.
Contact an authorised service
workshop.
workshop.
Contact an authorised service
workshop.
Contact an authorised service
workshop.
Inspect all attachment bolts for
engine and machine, and tighten
them if loose.
Remove the grass sack.
Clean the grass discharge
channel.
Clean the inner area of the
mower mechanism.