Idiomas disponibles
Idiomas disponibles
1. Turn the pressure control knob counterclockwise to the
minimum setting.
pressure.
3. Trigger the gun to remove any pressure that may still be in the
hose.
lock forward until it stops.
and unplug the sprayer.
water slowly on the top of the paint to
prevent the paint from drying. For other
materials, seal the material container or
keeping the return tube in the material.
plastic bag. Seal the bag shut.
8. Place the sprayer in a safe place out of the sun for shortterm
storage.
1. Remove the gun from the plastic bag.
cover from the paint hopper or material container and stir the
paint for all other materials.
and that the pressure is completely reduced.
to increase the pressure.
6. Test the sprayer on a practice piece and begin spraying.
i
Attention
Trigger locked
Use the following procedure to clear the material out of the paint
(gun will not spray)
hopper of a hopper unit.
2. Turn the pressure control knob
5. Direct the return tube into the original
8. Turn the pressure control knob counterclockwise to the
9. Trigger the gun to relieve pressure and lock the gun.
10. Remove the spray tip and guard and place them into a
11. Fill the paint hopper with water or an appropriate solvent for
12. Direct the return tube into a waste bucket.
Use the following procedure to clear the material out of the suction
tube of a suction set unit.
1. Turn the pressure control knob counterclockwise to the
4. Wait a couple seconds, then trigger the gun into the material
6. Remove the suction hose from the
9. Turn the pressure control knob counterclockwise to the
10. Place the attached suction tube and return hose into the
trigger lock forward until it stops.
counterclockwise to the minimum
setting.
material container.
will draw the remaining material in the paint hopper through
the pump, up the return tube, and into the material container.
minimum pressure setting.
container of water or appropriate solvent for the type of
material with which you are painting.
the type of material with which you are painting.
of the pump, the paint hopper, and the return tube.
minimum setting.
trigger lock forward until it stops.
material and hold it above a bucket of
the material container.
remaining material in the suction tube through the pump,
down the return hose and into the material container.
minimum setting.
container of water or appropriate solvent.
Trigger locked
(gun will not spray)
Trigger locked
(gun will not spray)
GB
