Idiomas disponibles
Idiomas disponibles
The key to a good paint job is an even coating over the entire surface.
This is done by using even strokes. Keep your arm moving at a
constant speed and keep the spray gun at a constant distance from
the surface. The best spraying distance is 10 to 12 inches between the
spray tip and the surface.
Light Coat
Do not flex wrist while spraying.
Keep the spray gun at right angles to the surface. This means moving
Even coat throughout
Keep stroke smooth and at an even speed.
Keep the spray gun perpendicular to the surface, otherwise one end
of the pattern will be thicker than the other.
Approximately
10 to 12 inches
Right way
Wrong way
GB
Heavy Coat
Light Coat
Approximately
10 to 12 inches
stroke. This will save material and avoid material buildup at the end
of the stroke. Do not trigger the gun during the middle of a stroke.
This will result in an uneven spray and splotchy coverage.
Proper way to trigger the spray gun
Keep stroke
even
Start stroke
Pull trigger
When you stop painting, lock the gun trigger lock, turn the pressure
control knob counterclockwise to its lowest setting and set the
and unplug the sprayer.
with sharp cutting edges.
2. Turn the pressure control knob counterclockwise to its to its
lowest setting.
Pressure Control Knob
PRIME/SPRAY Valve
4. Turn the pressure control knob clockwise to its highest
5. Unlock the gun trigger
lock by turning the switch
so that it is parallel to the
handle.
6. Trigger the spray gun to
bleed air out of the hose.
the spray tip, spray a test
area to check the spray
pattern.
8. Use the lowest pressure
setting necessary to get
a good spray pattern. If the pressure is set too high, the spray
pattern will be too light. If the pressure is set too low, tailing
will appear or the paint will spatter out in blobs rather than in
a fine spray.
6
Aproximately
10 to 12 inches
Keep steady
Release trigger
Good spray pattern
Paint tailing pattern
© Wagner. All rights reserved.
End stroke
