Idiomas disponibles
Idiomas disponibles
stops.
Trigger locked
(gun will not spray)
2. Thread the tip guard onto the gun. Tighten the nut first by
hand, then tighten more firmly with a wrench.
i
Begin
tightening
the tip guard
at this angle
1. Firmly press the optional pusher valve button on the side of
the pump housing to make sure the outlet ball valve moves
freely.
GB
Trigger unlocked
(gun will spray)
to achieve
the desired
spray angle
when tight.
Pusher Valve Button
(optional)
1. Attach the high pressure hose to the paint sprayer. Use a
wrench to tighten the paint hose securely.
2. Attach the spray gun to the other end of the high pressure
hose. Tighten the hose securely to the gun using two
wrenches.
3. Plug the sprayer into a properly grounded outlet or heavy
feet of cord. If you must spray a long distance from a power
100 feet in length.
1. Fill the inlet valve with water or
with a light household oil.
valve is set to PRIME and that
the pressure control knob is
turned counterclockwise to the
lowest pressure setting.
4. Increase the pressure by turning
the pressure control knob
5. Force the inlet valve to open
and close by pushing on it with
a screwdriver or the eraser end
of a pencil. It should move up
oil is sucked into the sprayer.
This will wet the moving parts
and break loose any old paint
residue.
6. Put the palm of your hand over
the inlet. Turn the pressure
control knob clockwise to its
feel suction coming from the
inlet valve. If you do not, see
the section on cleaning and
servicing the outlet valve.
knob counterclockwise to the
minimum pressure setting.
4
© Wagner. All rights reserved.
