Network Interface - Tripp-Lite SRCOOL60KCW El Manual Del Propietario

2. Introduction

2.8 Network Interface

1 Network Port: Connects to the Ethernet Network.
2 LED Indicators: When the interface is initializing, the two LED indicators simultaneously flash to show its status.
• Rapid simultaneous flashing (every 50ms): Initialization in progress.
• Slow simultaneous flashing (every 500ms): Initialization failed.
WARNING: Do NOT disconnect the cooling unit's input power during initialization. This could result in data loss or
damage to the network interface.
The green (left) LED indicator shows the network connection status:
• ON: Network connection established and the IPv4 address is useable.
• OFF: Not connected to a network.
• Flashes slowly (every 500ms): Faulty IP address.
The yellow (right) LED indicator shows the linking status between the interface and the system:
• Flashes rapidly (every 50ms): Communication established.
• Flashes slowly (every 500ms): No communication.
3 Console (COM) Port:
• Connects to a workstation with the provided RJ45 to DB9 cable for system configuration.
• Connects a TLNETEM environmental monitoring device (optional).
4 Reset Button: Resets the interface. This does not affect the operation of the cooling unit.
5 DIP Switches: Set up operation modes.
DIP Switches Operation Mode
Normal Mode
Pass Through Mode
Sensor Mode (with TLNETEM)
Configuration Mode
1 3
NETWORK COM
RESET
NET UPS
2
Description
Provides the cooling unit's status information and parameters over the network.
Stops polling the cooling unit but transfers the communication data between the
console port and the cooling unit.
Collects data from an optional TLNETEM. It provides not only the cooling unit's status
and parameters, but also the TLNETEM's status information and environmental
parameters.
In this mode, the user can login through the console port and configure the
interface's settings.
9
4 5