Side Panel Removal - Tripp-Lite SRCOOL60KCW El Manual Del Propietario

3. Installation
Hold-down bracket
The hold-down bracket support is used to fix the cooling unit to the pallet during transportation. The bracket can also be used to secure
the unit to the ground after positioning.
1
Use two M6 screws to secure the hold down bracket to the frame below the front door (with the extruding part forward)
2
Use expansion screws to secure the extruding end to the floor.

3.5 Side Panel Removal

If side panel is locked, use the attached key to open it. Two latches are located on each of the two side panels. Press the latches
downward at the same time and remove the side panel.
To reinstall a side panel, align the two lower holes and press down the latches at the same time.
1
1
(Figure 3-7 : Installation of L-type balance support)
(Figure 3-8 : Removal of side panel)
2 .
2
2
Expansion
screws
13
1
.
L-type
balance
support
Floor