Tripp-Lite SRCOOL60KCW El Manual Del Propietario página 18

3. Installation
2
Use nippers to remove the cover plate's knock-outs
2
glands' nuts , use the nuts to fix the cable glands on the cover plate, and pass the power wires through the cable glands
Power supply's
cover plate
3
The SRCOOL60KCW is factory pre-wired for single input installation. Use a screwdriver to remove the two jumpers connecting
number 1 and number 3 terminals, and number 2 and number 4 terminals (see Figure 3-18 below).
4
Use a screwdriver to loosen the wiring terminal block screws and use ring-type terminals to secure the wires into the terminal block.
230V Installation
Wiring terminal block
5
Re-install the power supply's cover plate and tighten the cable glands.
1 , remove the two cable glands from the accessory package, remove the cable
Cable
glands
1
2
2
Nuts
Knock-outs
(Figure 3-17 : Insertion of power wires)
Wiring terminal block
(Figure 3-18: Removing pre-installed jumpers)
(Figure 3-19 : Installation of power wires)
Power wires
Press the knob

(Figure 3-20 : Re-install the power supply's cover plate)
Main
power
wires
3
208V Installation
Wiring terminal block
Power wires
Rotate the cable glands clockwise

18
3
.
Standby
power
wires
3