Important - Davey DPLGEU Instalación E Instrucciones De Funcionamiento

• When sliding the probe into the probe housing, ensure that the probe is located more than ½ way into
the probe housing (refer Figure 6.17).
û
Probe not in
far enough
Figure 6.17
• Hand tighten the probe locking nut onto the probe housing, that will in turn tighten the washer onto
the o-ring (and create a seal). Periodically check the tightness of the locking nut, to ensure probe
remains in place.
• It is a good idea to periodically check the nuts securing the probes onto the manifold to ensure they
haven't come loose.
IMPORTANT: Ensure that the probe isn't inserted too far into the probe housing.
Pushing the probe against the inside of the probe housing (on the underside) risks
breaking the glass. Do not over tighten the probe locking nut onto the probe housing.
Probe locking nut
Washer
O-ring
Figure 6.16
ü
23
End of glass probe
û
Probe in
too far