Davey DPLGEU Instalación E Instrucciones De Funcionamiento página 20

Figure 6.9
ATTENTION: When packaged, the probe comes connected to a bottle of chemical
solution (refer to technical specifications section for MSDS availability). Do not drink
the solution. The excess solution should be kept for future winterising of probes.
• Carefully unscrew the bottom half of the bottle, from the bottle's lid (refer Figure 6.10). Do not attempt
to pull the whole bottle off the probe as you risk damaging the glass probe end;
Figure 6.10
• Now carefully slide the lid and o-ring off the end of the probe. Ensure the glass probe end remains
intact and ideally untouched (refer Figure 6.11). If the glass probe end is smashed, the probe will need
to be replaced (see Davey part # 16166). If the probe is touched, simply use a soft cloth, or tissue to
clean, then resoak the probe in its chemical solution for 60 seconds;
ph calibration:
put probe into
ph 7 solution
–>ok
20