PROTEOR 1M01 Instrucciones De Uso página 7

5. ACCESSORIES AND COMPATIBILITY
Reference
Upper joint
Lower joint
6. MOUNTING AND FITTING ON THE PATIENT
A. Alignments
Static alignments:
In the sagittal plane, the load line runs via the Trochanter, between 5 and 10 mm in front of
the knee axis.
Make sure to respect the patient's flexum.
For the foot, comply with the alignment instructions from the manufacturer.
In the frontal plane, the load line will run via the middle of the knee and the foot.
Dynamic alignments:
In normal walking, after fitting the cable and the various settings set out below, the knee must
be extended during the stance phase.
Check the alignment using an appropriate tool (laser, plumb line, etc.)
B. Fitting
Tube holding collar tightening torque:
•
1M01 / 1M10: 11Nm
•
1M01-P6 / 1M10-P6: 5Nm
Adhere to the tightening order and torque of the screws on the tube (diameter 34 mm) on the -P6
version:
1. Tighten screw V1 to 5 Nm
2. Tighten screw V2 to 5 Nm
3. Retighten screw V1 to 5 Nm
C. Setting
For the patient's safety, the orthopaedic prosthetist must perform the initial test with the factory
settings, between parallel bars.
The foot model used may influence the knee settings. The knee should be set whenever the foot
has been replaced.
After any maintenance operation, the knee will need to be set again.
Using a 3 mm Allen key, tighten or loosen the screw (1) until you obtain the desired setting.
Systematically check that the knee locks in extension (locking noise and lever free movement
amplitude = approx. 2 mm)
D. Cable fitted (version 1M01 & 1M01-P6)
1. Place the spacer (3) between the branches of the lever (2)
2. Insert the screw (4) into the spacer (3)
3. Engage the nut (5) onto the screw (4)
4. Insert the rivet (6) into the nut hole (5)
5. Place the cable (7) in the rivet (6)
6. Adjust the length of the cable (7)
7. Tighten the screw (4) to lock the cable
8. Cut off the excess cable
9. Mount the cap (8) on the nut (5).
E. Friction setting
1. Unlock the central screw (9) using a 2 mm Allen key.
Tie-plate
Connectors 1K160 / 1K163 / 1K03(-P6) / 1K30
Tube
USER MANUAL
1M01 / 1M10
1K40
Ø30 mm
1M01-P6 / 1M10-P6
1K160-P6 / 1K03-P6
Ø34 mm
V1
V2
9 & 10
8
Page 2 of 4
5 to 10 mm
Load
line
5 Nm
1
2
Tightening
torque:
Section 6.B.
7
4
6
5 3