Mounting The Wall Arm - Dräger Polaris 50 Instrucciones De Montaje Y Uso

EN_GB
CAUTION
Take account of the wall bearing position

The wall bearing must be aligned in
accordance with the drawing

Failure to comply with correct alignment will
compromise mechanical safety

Make 4 bore hole markings

Check clearance

Drill holes, then blow them out using bellows

Use tubular dowel for the selected screws
and tighten

Wall bracket in vertical alignment, mount with
M8 self-locking bolt 1 (20 Nm / 14.75 lbf ft)

Tighten all 4 threaded pins 2 (5 Nm / 3,68 lbf
ft)
32
DANGER
Electric shocks are life-threatening.

Disconnect or remove the fuses before
working on the mains connection

Connect to mains

Push hood with ring onto the wall bracket

Connect luminaire cable

Push cover against the wall

Tighten firmly with ring
7.3

Mounting the wall arm

WARNING
The cantilever arm is an injury hazard

Do not remove the transport safeguard until
after the luminaire head has been mounted.

Loosen the screw connection and remove
the cover cap with connector