Main Menu Description; Setting The Oxygen Concentration - SCUBAPRO UWATEC Galileo Luna Manual Del Usuario

2.1

Main menu description

Press "Menu" to view the list of menus.
To enter any menu, scroll up or down
the list via the "" or "" buttons until
the highlighted bar covers your menu of
interest, then press "entr" to confirm
your choice.
To change settings press the "+" or "–"
buttons, then press "SaVe" to confirm
the changes. This will take you back to the
main menu. If you do not want to confirm
the changes, press and hold the right
button at any time to exit without saving
the changes. This will also take you back
to the main menu. Press and hold the left
and the right button simultaneously to jump
back to the time of day display. Note that
holding down the "+" or "–" buttons makes
the setting change faster.
If you make a change in any menu and
you save it, the computer will display
the message cHanGeS SaVed for
2 seconds. If you make a change and
do not save it, the computer will display
the message cHanGeS not SaVed
for 2 seconds. If no changes were made,
whether you exit by means of a press or a
press and hold, no message is displayed.
2. Menus, settings and functions
If more than one entity can be changed
within a single menu, the right button is
labeled ">>" instead of "SaVe". Pressing
">>" will move the highlighted segment
to the next entity that can be changed.
When the highlighted segment is on the
last possible entity that can be changed,
the right button reverts back to "SaVe". In
case of submenus, the operation follows
the same process.
If in the middle of changing a setting the
computer does not receive any input for
a period of 3 minutes, it will automatically
switch back to the time of day display
without saving any changes.
2.2 Setting the oxygen
concentration
Upon entering this menu, the current
oxygen concentration
highlighted. Underneath the O
see the ppO and the corresponding MOD.
2
After changing the oxygen concentration,
the ppO will be highlighted. You can
2
change its value between the maximum
allowed value (see section 2.3.4) and
1.0bar. As you change the ppO
MOD changes accordingly. Note that the
MOD is also a function of water type (salt
or fresh) and of atmospheric pressure (and
hence altitude).
(O %) will be
2
% you can
2
value, the
2
17