Desaturation Reset; All-Silent Mode - SCUBAPRO UWATEC Galileo Luna Manual Del Usuario

2. Menus, settings and functions

2.3.7 Desaturation reset

Galileo allows you to reset the desaturation
in the computer. Any tissue saturation
information from a recent dive will be
reset to zero and the computer treats the
next dive as a non-repetitive dive. This is
useful when the computer is loaned to
another diver who has not dived in the last
48 hours.
! WarninG
Diving after having reset the desaturation
is extremely dangerous and is very likely to
cause serious injury or death. Do not reset the
desaturation unless you have a valid reason to
do so.
To prevent accidental desaturation reset,
you must enter the safety code once you
decide to proceed with the reset. The
safety code is 313. Once inside the menu
the word code will appear. To enter the
code, use the "+" and "–" buttons to define
the first digit (3), then press ">>" to confirm
it. Now define the next digit (1), confirm by
pressing ">>", then define the last digit
(3). Pressing "SaVe" after having defined
the last digit will complete the desaturation
process. The display shows the message
deSaturation reSet SucceSSfuL
for 2 seconds. Note that the reset of the
desaturation is entered into the logbook for
tracking purposes.
F
NOTE:
Removing and replacing the battery
will not reset the desaturation. Galileo
stores tissue saturation information
in non-volatile memory. For the time
during which the computer is without
battery, the desaturation calculation
is frozen and resumes from where it
had left off as soon as a new battery is
installed.
20
2.3.8 All-silent mode (default: OFF)
In this menu you can turn off the sound so
that the computer will not beep under any
circumstance. Setting the aLL-SiLent
mode to on overrides any setting you
choose for individual warnings (described
in section 2.6) and also mutes all alarms
(described in section 3.2). The wake-up
alarm will also be disabled.
! WarninG
Muting all alarms can lead you into potentially
dangerous situation and could result in serious
injury or death.
If you choose aLL-SiLent on, you will be
required to enter an additional confirmation
in the form of a safety code. The safety
code is 313. This prevents unintentionally
setting the aLL-SiLent to on. To enter
the code, use the "+" and "–" buttons to
define the first digit (3), then press ">>"
to confirm it. Now define the next digit (1),
confirm by pressing ">>" then define the
last digit (3). Upon pressing "SaVe" after
having defined the last digit, aLL-SiLent
will be set to on and you will have no
audible signals of any kind. The display
shows the message aLL-SiLent on
SucceSSfuL for 2 seconds.