Setting The Oxygen Concentration When Diving With More Than One Gas Mixture; Gas Summary Table - SCUBAPRO UWATEC Galileo Luna Manual Del Usuario

programmed and used for diving with more
than one gas mixture whether you use
transmitters or not.
6.1 Setting the oxygen
concentration when diving with
more than one gas mixture
To set the oxygen concentration for tanks
T1, T2 and TD you need to access the
O setting menu.
2
While TaNK is highlighted, use the - and
+ buttons to choose the tank for which
you want to set the oxygen concentration.
Press >> to highlight ON or OFF, and use
the - and + buttons to toggle between the
two. Press >> again to move down one line
to the oxygen concentration. After setting
the oxygen concentration, pressing >>
moves you down one line to the ppO
Note that the MOD for tanks T2 and TD
is actually the switch depth that Galileo
will use for its calculations, warnings and
suggested gas switch point. Press SaVe
to save your settings.
F
NOTE:
- Galileo considers in its algorithm
only gas mixtures whose tanks are
set to ON in the O
- The oxygen concentration of T2
can only be set after having set the
oxygen concentration of TD.
- Setting the ppO
applies to tank T1 only. Tanks T2 and
TD are always limited to a maximum
value of ppO
- For oxygen concentrations of 80%
and higher, the ppO
1.6bar and cannot be changed.
- The oxygen concentration of T1
cannot be set to OFF.
4
max.
2
settings menu.
2
max value to OFF
2
max of 1.6bar.
2
max is fixed at
2
- The oxygen concentration of T2
can only be set to a value between
that of T1 (equal or higher) and TD
(equal or lower).
- Galileo adds the label T1, T2 or TD
next to the O label and between
2
the tank pressure and RBT labels to
identify the currently active tank.
- The ON/OFF option for each
tank allows you to easily go from
3 to 2 or even to 1 gas mixture
without changing the actual oxygen
settings.
- If you set tank TD to OFF, T2 will
automatically be set to OFF also.
- The MOD for tanks T2 and TD is the
switch depth for the corresponding
gas. This is what Galileo uses for its
calculation, alarms and suggested
switch points.
- Galileo does not allow MODs of
different gases to be less than
3m/10ft apart.
- Setting a tank to OFF does not affect
the pairing of the corresponding
transmitter.
- When diving with more than one
gas mixture, the Nitrox reset time
function has the following effect:
o T1 is set to 21%
o T2 and TD are set to OFF.
6.2

Gas summary table

When more than one gas mixture is set,
Galileo lists the tank pressure, oxygen
concentration, ppO max and MOD for each
2
tank on the GaS SUMMaRY TaBle. If a
tank designation has not been paired, NO P
appears instead of the pressure. If the tank
designation has been paired but Galileo is
not receiving a signal, "---" appears instead
of the pressure.