Warranty - SCUBAPRO UWATEC Galileo Luna Manual Del Usuario

! WarninG
- Never touch the metal surface of the battery
with bare fingers. The two battery poles
must never be short-circuited.
- A leaking transmitter cap may lead to the
destruction of the transmitter by water
seeping in or cause the transmitter to
switch off without prior notice.
- Always open the transmitter in a dry and
clean environment.
- Only open the transmitter to replace the
battery.
1. Remove the transmitter from the HP
port of the first-stage regulator.
2. Dry the transmitter with a soft towel.
3. Remove the 3 screws with a Phillips
screwdriver.
4. Carefully remove the transmitter cap.
5. Carefully remove the transmitter cap
o-ring. Be careful not to damage the
sealing surfaces.
6. Remove the battery by holding it on
both sides. Do not touch the contacts
or the electronic parts.
! WarninG
If you notice traces of seeping water, damages
or other defects on the o-ring, do not use the
transmitter for further dives. Take it to an
authorized SCUBAPRO UWATEC dealer to be
checked.
7. Always insert a new o-ring when you
replace the battery and dispose the
old o-ring. Make sure that the new,
lubricated o-ring is in perfect condition,
and that o-ring, o-ring groove and the
sealing surface of the transmitter and
transmitter cap are free of dust and
dirt. If necessary, clean the parts with
a soft cloth. Fit the o-ring in the o-ring
groove.
5. taking care of Galileo
8. Wait for 30 seconds, then insert the
new battery. Ensure that the "+" side
is facing away from the transmitter. The
transmitter can be damaged if you do
not insert the battery correctly.
9. The transmitter will now perform an
automatic test and switch into ready
mode after 60 seconds.
5.3

Warranty

Galileo has a two-year warranty covering
defects in workmanship and functioning.
The warranty only covers dive computers
which have been bought from an authorized
SCUBAPRO UWATEC dealer. Repairs or
replacements during the warranty period
do not extend the warranty period itself.
Excluded from warranty coverage are faults
or defects due to:
- excessive wear and tear
- exterior influences, e.g. transport
damage, damage due to bumping and
hitting, influences of weather or other
natural phenomena
- servicing, repairs or the opening of
the dive computer by anybody not
authorized to do so by the manufacturer
- pressure tests which do not take place
in water
- diving accidents
- improper placement of the battery cap.
For European Union markets, the warranty
of this product is governed by European
legislation in force in each EU member
state.
All warranty claims must be returned
with dated proof-of-purchase
authorized SCUBAPRO UWATEC dealer.
Visit www.scubapro.com for the dealer
nearest you.
to an
69