Full Screen Configuration - SCUBAPRO UWATEC Galileo Luna Manual Del Usuario

3. diving with Galileo
F
NOTE:
Only the shorter between no-stop
time and RBT is shown in LIGHT
configuration. If your remaining gas
supply is such that you will enter
level stops or deco prior to reaching
an RBT of 0 minutes, the no-stop
time will be displayed on the screen,
emphasized by the NO STOP label. If
on the other hand your remaining gas
supply is such that you will reach RBT
of 0 minutes while still in the no-stop
phase, then the RBT will be displayed
on the screen, emphasized by the
RBT label.
More specifically, the following information
is displayed:
- current depth
- dive time
- the shorter between no-stop time and
RBT
- tank pressure
- nitrogen loading (via bar graph)
! WarninG
After a PRESSURE SIGNAL LOST warning,
Galileo is not able to compute the RBT any
longer. In such case, the LIGHT configuration
shows the no-stop time but this does not imply
that you have enough gas supply to remain at
that depth for that amount of time.
Upon pressing the middle button (marked
"More"), you can retrieve alternate
information.
instead of the tank pressure and stays
on the display only for 4 seconds, after
which the tank pressure is shown again.
The alternate information appears in the
following sequence:
- maximum depth
- O %
2
- temperature
- buddy tank pressure (only if Buddy
tank designation has been paired, see
section 1.11)
- (active MB level if different than L0)
- (no-stop information relative to L0 if an
MB level between L1 and L5 is active,
see section 3.5.3)
50
This information appears
- time of day
- CNS O
2
Each time you press the button the
information changes to the next one in the
sequence and stays there for 4 seconds
before reverting to the tank pressure. If you
press the "More" button again after the
field has reverted to your tank pressure, the
sequence of additional information will pick
up again from the last displayed data.

3.3.4 FULL screen configuration

This screen configuration is meant for
those divers that prefer to have as much
information as possible displayed at once.
More specifically, the following information
is displayed:
- current depth
- dive time
- no-stop time (only during no-stop phase
of dive)
- deepest stop, duration of deepest
stop, total ascent time (only during
decompression phase of dive)
- tank pressure
- RBT
- time of day
- stopwatch
- active MB level
- CNS O
2
- temperature
- average depth